Another important goal for us was to avoid the overlapping dials found in so many modern Zeniths. These are often criticized by collectors, even fellow Zenith watches homepage Replica fans, although I’ve never personally found it to be troubling. The overlapping sub-dials matched the effortless avant-garde nature of the tri-color El Primero quite well, being almost flippant with its design. That sort of brashness works well on overtly sporty models, should a brand be gutsy enough to actually try it, but for a much dressier, more austere model like the Timeless Chronomaster Heritage it wouldn’t do. Naturally, we wouldn’t dare modify the El Primero within to space the sub-dials out further, so we were necessarily restricted as to where the sub-dials must be located. The solution was self-evident: the sub-dials had to be smaller. Although reduced in size, they’re now as large as they can possibly be without overlapping, and to aid in legibility, there is a subtle ring, a change in texture, around each sub-dial which helps separate it from the surrounding dial without need for an outline or applied marker.One of the other important changes we made was moving to a new case. We chose the Heritage 146 case due to its size and classic design. As is so often the situation for our limited editions, we opted to use a 38mm size. In general, we use 38mm cases because we find it to be a very versatile size, and in a small run limited edition we want to reach the broadest variety of collectors possible. You’ll also notice in this photo that the crown is quite a bit thinner than the Heritage 146’s crown. The A273’s crown was also fairly thick, but again, we felt that the slightly thinner crown was more consistent with its dressier image. Being an accurate, automatic watch with no need to set the date, the crown won’t be needed particularly often to begin with. You’ll also notice that the pushers have a small groove in them, another subtle difference from the original.